/
Buzzer

Buzzer

image-20250528-050119.png

 

Buzzer is used to notify driver about special events: authentication requirement, over speeding, harsh driving, unauthorized ignition.

 

 

 

XG37 Series

  • Light

  • Light+

  • XtCAN

  • Tacho

LX40 Series

  • LX41

  • LX42

  • LX43

  • LX44

  • LX45

XG47 Series

  • XG47 RS232

  • XG47 CAN

1. Physical Connection

All devices are equipped with at least one open-drain output. These outputs do not provide voltage on their own, instead they pull the line to ground (0V) when active.

Best to connect Red Buzzer wire to constant power, black - to output.

1.1 Wiring Diagrams

This should be used as an example. Buzzer can be wired to any of available digital outputs.

image-20250521-123040.png

 

image-20250521-123058.png

 

image-20250521-123139.png

 

image-20250521-095501.png
image-20250521-123232.png
image-20250521-124755.png
image-20250521-124909.png

 

2. Adjustments in Logic Template

Device output needs to be configured in XDM configuration template ‘Hardware'->’Outputs'->'{output where buzzer was connecter}'->'OUTx settings'. Output can either be controlled by Static signals 1-5, (static signal is controlled through script, SMS, GPRS commands) or directly through script. For scripting examples look into script exampes.

image-20250521-125301.png