GeneralBitConfig

GeneralBitConfig


5.1a GeneralBitConfig:

Function

Description

Function

Description

Plane mode

Disables GPS supervisor algorithm (to detect higher speed). After activation speed meaning would be:
229 = 229 km/h
230 = 230-239 km/h
231 = 240-249 km/h
232 = 250-259 km/h
….
255 = 480 km/h

Odometer enable

Enables internal odometer (mileage counter).

Force TCP socket create

Forces device to create new TCP socket, when data packet is ready for sending (by default device waits a 10 min period until creates new socket).

Reset wiegand value

Reset identificator value sent via wiegand26 protocol.

Replace GPS speed to CAN bus

Replaces speed source. From GPS to CAN bus speed.

Note. Use only if CAN bus connected and speed from CAN line available.

1 wire use single device

-

Disable position pining

Disables position pining algorithm. Used for slow moving objects (f.e. agro machinery).

Disable fuel approximation

Disables internal fuel approximation. Used for analog fuel level sensors.

Enable wiegand26

-

Disable events

Disables system events.

Note. Be aware that system events help us define device issues, turning them off, might cause lack of information about device behavior.

Disable data sending

-

Reset iButton value

Reset identificator value sent via 1-WIRE protocol.

Continuous odometer mode

Enables absolute counter mode for internal odometer.

Note. Value starts counting from 0, from the moment device is activated.

IN4 push push to S1

-

IN6 source ADC5

Changes IN6 virtual parameter source (by default it is related to ADC3).

Enable CAN fuel

Enables CAN fuel approximation.

 

5.1b GeneralBitConfig2:

Function

Description

Function

Description

Phone book from ID list

Enables special algorithm for telephone number storing in internal device memory.
This functionality is described under section SIM number list for SMS commands.

Disable inputs delay

 

Private trip

Disables GPS position, but counts odometer.

S1 to IN11

IN11 will represent status of StaticSignal1 instead of Out2

S2 to IN12

IN12 will represent status of StaticSignal2 instead of Out3

1W any family to ID

Enables any 1-wire sensor to be used for identification (for example ID of temperature sensors)

Reserved

-

Reserved

-