/
Eurosens Direct CAN

Eurosens Direct CAN

image-20250526-061045.png

Eurosens Direct fuel level sensor is supported on Xirgo Global devices with CAN communication.

 

 

 

 

XG37 Series

  • XtCAN

  • Tacho

LX40 Series

  • LX44

  • LX45

XG47 Series

  • XG47 CAN

1. Physical Connection

Eurosens Direct CAN version wire color coding:

Yellow

Green

Brown

White

CAN H

CAN L

+V power

Ground

 

When wiring Eurosens flowmeters multiple sensors can be connected following same topology as bellow, connect all flowmeters CAN H lines with CAN H line of Xirgo Global unit and same CAN L, connect all lines with CAN L of the unit.

Important to note if connection is made straight from Xirgo Global unit to Eurosens Meter CONFIGURE 120ohm resistor in meter settings. For this enable “Terminator“ option in meter settings.

image-20250526-073248.png

For more detail look into 3. Eurosens Meters Documentation

image-20250526-073115.png
image-20250526-073105.png

2. Adjustments in Configuration

2.1. Adding Script

In configuration template ‘Script'->’Script1'->'Script' select ‘BCE_MEAS_DeltaCANSCR8_3’ script. When script is added script settings will appear below. If script is not present in script list contact out support team.

image-20250526-073901.png

2.2. Configuring Script Settings

In newly appeared tab ‘Fuel flow meter data read settings' select sensor values you want to be saved on desired user defined sensors. It is also important to select correct XG device CAN channel where meters was connected.

image-20250526-074444.png

2.3. Displaying in Monitoring Platform

For more in depth configuration of device configuration visit Quick Set Up Of Configuration

For device to report sensor values to telemetry platform sensors needs to be included into telemetry payload.

image-20250526-074553.png

3. Eurosens Meters Documentation

Official documentation containing technical specifications, calibration and configuration info of Eurosens Flow Meters.