Main steps how to get your unit active and ready for operation.

Note: We strictly recommend making the first activation in your office, using a reliable test bench.

I. Physical connection

1. Open the device, put the SIM card in (PIN code must be taken off, preferably SIM with ability to receive SMS messages).

2. Connect the device to the external power source (at least 8V). 3 wires are enough for testing and device activation:

   Plus (red wire) connect to the Plus of power supply.

   Minus (black wire) connect to the Minus (ground).

   IN5 (gray/black wire) connect to the plus of power supply (it is for testing in the office only, in the vehicle it should be connected to Ignition wire).

II. Device configuration

Step 1: Open the configuration web tool: https://xdm.xgfleet.eu/
Go to Devices tab. You will see all your devices. To find a specific device, enter its IMEI or part of it in search parameters section.

Open

Step 2: Devices are identified by IMEI number.
Click on the edit button in the actions menu to open device settings.

Open

Step 3: Select preferred settings template for the device (Config) and save device settings.

Note: Setting template must be created before assigning it to the device (see instructions below).

III. Setting templates

Setting template is main operating script, which will be followed by device - it controls interfaces, data sending, times, track quality, parameters, outputs and more.

Open

Note. Normally, you should have in your account at least one default template, created by our team, so use this default template.

You can use existing template, create new, or duplicate existing template and make needed adjustments.

Open

Check our documentation on main steps in adjusting template: Quick set up of setting template.

General information on all fields of Setting template, find here: Structure of setting template.