/
Tachograph read configuration in XDM portal (FMS500 series)

Tachograph read configuration in XDM portal (FMS500 series)

Device must be pre-configured properly, before installation in order to successfully read data from digital tachograph.

 

Step 1: Specify IP and port of authorization server.

  1. If you are using direct mode, this will be your IP address.

  2. If you are using retranslated mode, you must copy server ID from the tachograph receiver application.


Step 2: Specify IP and port of data files server.

a. If you are using direct mode, this will be your dedicated port.

b. If you are using retranslated mode, port will be 7511 by default.


Step 3: Enable tachograph read function in the logic template.

Step 4: Select parameters, which should be sent to your server.